LED Display 4 Placing Tank Solder Paste Machine Solder Paste Warm
Up Machine
Introduction
Solder paste check right machine, also called solder paste warm up
machine, and solder paste aging machine, with the timer, the
machine can easily achieve the control of the solder paste
temperature warm up time, which can save much time to record the
time of solder paste back to the ambient temperature after take out
off the refrigerated room. It is a efficiency way to control the
temperature of the solder paste, make sure the activity of the
solder paste, ensure the printing quality, better to control the
production plan, improve production efficiency.
SMT manufacturers usually store solder paste in sealed and
refrigerated refrigerators to meet quality assurance requirements.
The solder paste is usually refrigerated at a temperature of 0-10
degrees Celsius and sealed to prevent oxidation. The solder paste
needs to be tempered before use. Usually the tempering time is
about 4 hours. The purpose is to restore the activity of the
refrigerated solder paste and make it easier to use.
Our solder paste rewarming machine is an intelligent management
device that integrates solder paste refrigeration storage,
rewarming, stirring, traceability and direction traceability
functions. The refrigeration temperature can be controlled within
the range of 1-10 degrees Celsius, and the temperature can be
controlled through numbers and temperature. Curve monitoring and
recording, first in first out, to meet the storage and use
requirements of different solder pastes.
The reheating function of the solder paste reheating machine can
control the reheating temperature at 18°-28°. Users only need to
set the reheating temperature according to different types and uses
to ensure that the reheated solder paste can be used with Room
temperature remains consistent. The reheating method of our solder
paste reheating machine is mainly controlled by the exhaust fan,
rather than the heating mode, which will not affect the quality of
the solder paste after reheating.
In order to meet different usage scenarios, our solder paste
reheating machine has three modes: automatic reheating of solder
paste, manual scheduled rewarming, and recuperation by receiving
MES work orders to ensure that it can be used right out of the box
every time. , greatly improving production efficiency.
Features
1, Each tank of solder paste placement slot has an independent LED
display time controller. After setting the time the solder paste
will be fixed in the slot and sink automatically,also it will
release automatically when time is over.
2. With FIFO fuction.
3. In the case of out of power accidently,even if not reach setted
time, solder paste bottle will automatically pop up.
4. Equipped with a automatic alarm system,when reach the setting
time, this machine will automatically alarm. Also there is a
emergency stop button for emergency suitation, easy operation and
security.
Specification
| Model | HS-SP-4N |
| Control system | PLC |
| Assemblying parts | Import parts |
| Power | AC220V, 50Hz |
| Air Pressure | 0.4Mpa |
| Placing tank | 4 tanks |
| Machine Demension | 500*300*220mm(W*D*H) |
| Gross Weight | 16KG |
Steps
1. After debugging, turn on the power.
2. Place the tin tin can to be warmed up into the grooved fixture.
3. Please turn on the corresponding power supply after the tin
incubation has returned to temperature and wait for it to return to
temperature.
4. Adjust the time setting on the panel to a better temperature
recovery time;
5. After pressing the power switch, the solder paste will
automatically sink. The machine begins to warm up until the tin
pops out after completion.
5. After use, turn off the power switch;
6 things to note
7. In case of power outage, if the set time is not reached, the tin
bottle will not be able to be taken out.
8 .Please keep the machine clean;
9. Check that all screws are not loose;
10. Check the main power switch of the machine before returning to
temperature;
